Rockin it....part II

Well, before I started on the rocker panel on this side, I needed to tackle that filler-infested rear part of the rear fender. Here, the patch panel is stiched in. I had to set the welder really really really cool because there was spots all over in the left side that just burned right through, even with just a quick 2-3 second spot-weld. This panel was really pretty easy to fabricate, it's just a square piece of metal that's rounded down. -TH



Here's the finished product, after the welds are ground down. Hard to believe its the same panel. There's still a small piece at the end of the fender lip (at the bottom) that still needs to be cut back. -TH


Yeah...so here's the rocker from the passenger side. Not as bad as the drivers, but nasty enough to house an ancient civilization of mice at one time. Yum. There was actually bare, clean metal on the inside of this rocker that didn't have a speck of rust on it. Crazy. -TH



I figured I'd just cut to the chase on this one...you've seen the other side. Here this rocker is, done. Notice, once again, all the holes down the door to pull out the metal at one time. -TH